CAME ZM3E - Error Messages and Troubleshooting; Encoder and Safety Errors; Input and Operating Time Errors

p. 29 - Manual FA01317-EN - 01/2020 - © CAME S.p.A. - The contents of this manual may be changed at any time and without notice. - Translation of the original instructions
ERROR MESSAGES
Encoder - ERROR The Encoder is disconnected.
The Encoder is broken.
Error! The Encoder is disconnected.
The Encoder is broken.
Safety test - ERROR The photocells are not correctly connected or confi gured.
Limit-switch - ERROR Malfunctioning limit-switch contacts.
Operating time - ERROR Finished the maximum work time set.
Safety devices - STOP Contact 1-2 (NC) is open.
C1 The (NC) contacts are open.
C3 The (NC) contacts are open.
C4 The (NC) contacts are open.
C7 The (NC) contacts are open.
C8 The (NC) contacts are open.