p. 3 - Manual FA01317-EN - 01/2020 - © CAME S.p.A. - The contents of this manual may be changed at any time and without notice. - Translation of the original instructions
• The electrical cables must pass through special pipes, ducts and cable glands
in order to guarantee adequate protection against mechanical damage. • The
electrical cables must not touch any parts that may overheat during use (such
as the motor and transformer). • Before installation, check that the guided part
is in good mechanical condition, and that it opens and closes correctly. • The
product cannot be used to automate any guided part that includes a pedestrian
gate, unless it can only be enabled when the pedestrian gate is secured. • Make
sure that nobody can become trapped between the guided and fi xed parts, when
the guided part is set in motion. • All fi xed controls must be clearly visible after
installation, in a position that allows the guided part to be directly visible, but far
away from moving parts. In the case of a hold-to-run control, this must be installed
at a minimum height of 1.5 m from the ground and must not be accessible to
the public. • If not already present, apply a permanent tag that describes how to
use the manual release mechanism close to it. • Make sure that the operator has
been properly adjusted and that the safety and protection devices and the manual
release are working properly. • Before handing over to the fi nal user, check that the
system complies with the harmonised standards and the essential requirements
of the Machinery Directive (2006/42/EC). • Any residual risks must be indicated
clearly with proper signage a xed in visible areas, and explained to end users.
• Put the machine’s ID plate in a visible place when the installation is complete.
• If the power-supply cable is damaged, it must be immediately replaced by the
manufacturer or by an authorised technical assistance centre, or in any case, by
qualifi ed sta , to prevent any risk. • Keep this manual inside the technical folder
along with the manuals of all the other devices used for your automation system. •
Make sure to hand over to the end user all the operating manuals of the products
that make up the fi nal machinery.
To Next Page
Loading...
Need help?
General
