Basic Operation
16
2. After pressing a button, turn the < > dial.
When a button is pressed, its function remains active for 6 or 16
seconds. You then look at the LCD panel and turn the < > dial during
this time. After the function turns off or when you press the shutter button
halfway again, the camera will be ready to take a picture.
Buttons which turn on for 6 or 16 seconds are indicated in this instruction
booklet with the following icons:
():The button's function remains active for 6 seconds after the
button is released.
():The button's function remains active for 16 seconds after the
button is released.
3. Just turn the < > dial.
While looking at the LCD panel, you can set the shutter speed, aperture,
or another setting.
1 After a button is pressed...
2 turn the < >.
SEC.01 P013-028 (E) 28-01-2003 10:20 Pagina 16
To Next Page
Loading...
