9-5 Imprinting color: Orange
9-6 Imprinting confirmation: None
9-7
Imprinting brightness
: Automatically set to suit DX-coded film speed.
9-8 QD power source: One CR2025 lithium battery (3 V) housed on the inside
of the QD back.
* The date is reset when the battery is replaced.
10. Power Source
10-1 Batteries: Two CR123A lithium batteries (6 V) loaded through the
camera grip bottom.
10-2 Battery check: Automatic battery check when the Command Dial is
released from OFF.
Battery level is always indicated on the LCD panel in one
of four levels.
10-3 Main switch: Command Dial set to OFF turns off camera.
11. Camera Specifications
11-1 Custom Functions: Thirteen Custom Functions (C.Fn-1 to C.Fn-13, 34
settings) provided.
* Settable with the Command Dial turned to C.Fn.
* For details, see the Custom Functions table on page 1-37.
11-2 Camera back: Opened with the camera back latch.
* Film window provided.
* No film memo holder.
* Not detachable.
11-3 Camera orientation Provided.
detection switch:
11-4 Flash contacts: X-sync direct contact on hot shoe.
* Speedlite locking pin hole provided.
* No PC terminal.
Part 1: General Information
1-25
Battery OK
Keep spare bat-
teries handy
Replacement warning
(Shutter release not locked.)
Replace batteries
(Shutter release is locked.)
To Next Page
