imageCLASS MF230 Series Service Guide for ASF
imageCLASS MF230 Series Service Guide for ASF September 2016
Page 10
C. Estimated Installation Time
The estimated length of time needed to unpack and install the machine is
approximately 5.2 minutes
3
. This is based on one (1) experienced technician
or end-user.
D. Notes on the Wireless LAN
• The imageCLASS MF232w machine is designed for indoor use, and must
be kept at a close distance (approximately 16.4’ (5 m)) from an access
point.
• It is recommended to check if masking is found. Communications between
walls and floors can deteriorate; therefore, arrange for the proper
installation of the machine to reduce any deterioration in communications.
• Radio wave interference may occur if radio wave equipment, such as a
microwave is near the machine, and it is in the same frequency band as
the radio wave used by the wireless LAN. Keep the machine away from
radio wave sources as much as possible.
3 This does not include the up to 2.0 minutes to install the printer driver.
To Next Page
Loading...
