PC-D320/PC-D340/FAX-L400 Chapter 4: Maintenance and Service
4-5
2.10 Transfer Guide
(1) Disconnect the power cord of the main unit from the power source.
(2) Open the right cover and remove the toner cartridge.
Store the toner cartridge in its original protective bag to avoid exposure to
light.
(3) Using a soft clean cloth, wipe any dust off the blank plate of the transfer
guide.
To avoid the deterioration of print quality, never touch the transfer charging
roller when you clean the metal strip.
2.11 Paper Pick-up Roller
Wipe with lint-free paper and remove any toner or paper debris.
2.12 Separation Guide
Wipe with lint-free paper and remove any toner or paper debris.
2.13 Transfer Charging Roller
Wipe with lint-free paper and remove any toner or paper debris.
Do not touch or hold the sponge section of the transfer charging roller. Doing
so can cause marks on back of paper or blank spots in copied images. Do not
use solvent.
Replace the charging roller it is deformed or cannot be thoroughly cleared
using lint-free paper.
2.14 Static Charge Eliminator
Wipe with a lint-free paper and remove any foreign matter, such as paper fragments.
2.15 Paper Feed roller
Wipe with lint-free paper and remove any toner or paper debris.
2.16 Fixing Entrance Guide
Wipe with a lint-free paper and remove any toner or paper debris.
2.17 Fixing Film
Using lint-free paper dipped in isopropyl alcohol, wipe of the fixing film.
2.18 Fixing Pressure Roller
Using lint-free paper dipped in isopropyl alcohol, wipe of the fixing pressure roller.
NOTE
To Next Page
Loading...
