150
V420 Could not start intelligent service [crit]
V421 Intelligent service error [crit]
Application (Memory Card) Messages
M001 Starting and stopping of SD control module
[info]
M203 Not enough space on memory card [warning]
M301 SD control module error [err]
Application (Camera) Messages
C001 Starting and stopping of camera control module
[info]
C002 Camera application started [info]
C201 Day/Night mode switching warning [warning]
C211 Camera control command overflow [warning]
HTTP Server Messages
H143 User name specification error [notice]
H144 Password specification error [notice]
H201 Timeout disconnect [warning]
Description intelligent initialization error [%1] [%2] .
(V420)
%1 Error number
%2 Cause of error
Meaning Failed to initialize intelligent service.
Countermeasure
If the problem persists after rebooting, the
camera is faulty. Arrange for servicing.
Description intelligent working error [%1] [%2] . (V421)
%1 Error number
%2 Cause of error
Meaning An error that does not permit recovery
occurred while intelligent service was
running.
Countermeasure
If the problem persists after rebooting, the
camera is faulty. Arrange for servicing.
Description %1 sdctrl (M001)
%1 Starting or stopping
Meaning The SD control module (sdctrl) has started
or stopped.
Description There is not available space (M203)
Meaning Insufficient memory card capacity.
Description %1 process failure (M301)
%1 mount or unmount
Meaning Mount or unmount process failed.
Description %1 camerad (C001)
%1 starting | stopping
Meaning The camera control module started/
stopped.
Description starting cameraappl (C002)
Meaning The camera application started.
Description Can’t switch Day/Night mode, because
current mode is Auto. (C201)
Meaning Could not switch day/night mode.
Countermeasure
Set Day/Night mode manually.
Description command queue overflowed (C211)
Meaning The camera control command queue
overflowed, and some commands were
discarded.
Countermeasure
Allow a longer interval (200 ms) for sending
the camera control command.
Description (http_auth.c.XXX) get_password failed,
IP:%1 (H143)
%1 IP address
Meaning An unknown user was specified in user
authentication.
Description (http_auth.c.XXX) password doesn't match
for %1 username%2, IP:%3 (H144)
%1 URL XSS vulnerability countermeasure
implementation (process equivalent to ftpd)
%2 User Name
%3 IP address
Meaning A wrong password was specified in user
authentication.
Description a request for %1 timed out after writing %d
seconds (H201)
%1 Request URI
%d 360 (Timeout time)
Meaning Disconnected due to HTTP server timeout
(360 sec.).
To Next Page
Loading...
