156
For top cover attachment, see the “Installation Guide”
included with the camera.
Important
If the reset switch is pushed, network-related settings will also
be restored to factory default settings including the camera's IP
address, subnet mask, default gateway address, etc.
Accordingly, you can no longer operate the camera from the
computer you were using to connect to the camera before.
When initializing the camera, use the “VB Initial Setting Tool”
installed in your computer to set an IP address appropriate for
the environment in which the camera is used (See “Performing
Initial Settings for the Camera” (p. 28)).
4
For VB-S30D/VB-S31D/VB-S800D, attach the top
cover.
Reset Switch
Reset Switch
To Next Page
Loading...
