156
If you select [Enable] and a timer event is triggered, video will be transmitted to the recording destination specified in
[Video Record] > [Upload] > [Video Record Action] (P. 144).
[E-mail Notification]
When [24-Hour Continuous Settings] is set to [Disable], select whether to send an e-mail notification depending on the timer
event.
If [Enable] is selected, e-mail notification is performed when a timer event is triggered.
To use e-mail notification, you must set [Video Record] > [E-mail Notification] (P. 148) beforehand.
[External Device Output]
When [24-Hour Continuous Settings] is set to [Disable], select the actions of the external device output at [Start Time] and
[End Time] of a timer.
[Repeat Interval] is not supported.
[Day/Night Mode Switching]
When [24-Hour Continuous Settings] is set to [Disable], select the Day/Night Mode switching behavior when a timer event is
triggered. This can only be set with [Timer 1].
Select [Switch to Day Mode] to switch to Day Mode at the start time, and Night Mode at the end time.
Select [Switch to Night Mode] to switch to Night Mode at the start time, and Day Mode at the end time.
[Repeat Interval] is not supported.
• If you set [Start Time] and [End Time] and select a preset with [Start Time Preset], the Day/Night setting in [Camera] > [Preset] >
[Camera Settings] > [Day/Night] (P. 118) is given priority. Therefore, even if you set [Day/Night Mode Switching] to [Switch to Day
Mode] or [Switch to Night Mode], the [Day/Night Mode Switching] setting will be disabled if the opposite setting has been configured
in [Preset] > [Camera Settings].
• When [Day/Night] in [Camera] > [Initial Settings] is set to [Auto] (P. 105), [Day/Night Mode Switching] will not happen when a timer
event is triggered.
• When the [Day/Night Mode Switching] settings switch Day/Night Mode, camera control privileges are released, even if the user has
obtained those camera control privileges using the Camera Viewer or other camera control applications.
HM4x
S30 S31
To Next Page
Loading...
