CanyCom CMX186 - Drive Train; Tires

-59-
Maintenance 5
Drive Train
• Stop engine and remove ignition key when servicing drive train.
• Allow machine to cool off before servicing. Engine and its ancillaries are very
hot after operation and may pose a burn hazard.
Tires
• Inate tires to the specied pressure. Under- or over-ination causes uneven
wear or other damages to tires.
• Dispose of drained oil properly.
Tire Size Pressure KPa(kgf/cm
2
)
Front Wheel
4.00-7 (4PR) 240 (2.4)
AGR 3.50-7 (2PR) 110 (1.1)
Rear Wheel
17×8.00-8 (4PR) 240 (2.4)
16×7.00-8 (2PR) 110 (1.1)
5332M-0507-010E
Valve Cap
1. Park machine on level ground.
2. Remove valve cap.
3. Check tire air pressure. If different from the
specied values, adjust pressure.
4. Put valve cap back in place.