Maintenance
-78-
5
• Do not set cutting height too low. It may hit ground.
NOTE
6. Move cutting rotary clutch lever to [ON] to rotate cutting blade to clean.
7. When cleaning is done, move cutting rotary clutch lever to [OFF] to stop cutting blade.
8. Move cutting height adjust lever to [150] for CMX227H and CM226H, [130] for
CMX186H and CM 185H.
9. Turn throttle lever to [ (slow)] to lower engine speed.
10. Stop machine and remove hose.
Hose Connection
5335M-0510-010E
1. Park machine.
2. Set cutting height to about 50mm.
3. Connect hose to hose connection. Run
water through hose.
4. Start engine.
5. Turn throttle lever to [ (fast)] to raise
engine speed.
To Next Page
Loading...
