Transporting
-88-
7
Hoisting
1. Lift seat.
2. Attach hoisting slings to 2 lift hooks and hoist
machine.
• Licence or certification is required to operate a crane. Check your local
regulations.
• Use hoisting sling of sufficient strength. Always use the slings of the same
length when more than one is used.
• Pay special attention to the center of gravitiy and the balance of machine when
hoisting.
2. Place loading ramps. Secure hooks oframps rmly and ush with loading deck.
3. Shift auxiliary transmission shift lever to [Low] and drive machine slowly forward onto
loading deck. Set cutting height adjust lever to [150] for CMX227H, CM226H, and [130]
for CMX186H, CM185H. Pay attention not to hit loading lamp or loading deck when
loading on a transporter.
4. Park machine according to the instructions in "Parking" (Page 33). Tie machine with
rope or tie-down belts and secure it onto loading deck of transporter securely.
5332M-0702-010E
Hooks
To Next Page
Loading...
