CanyCom SC45 - Chassis

Maintenance
-30-
5
Item Description
Schedule
Note
PSI
Mon
Year
Drive Train
Track
There shall not be any marked cut,
deterioration, or wear.
√ √ √
Track shall be properly tensioned; shall not
be too loose or too tight.
√ √ √
Adjusting: Page 39
Tension bolt shall be free of deformation or
corrosion.
√ √ √
Transmission
Transmission shall not jump out of the gear.
Irregular noise or overheating shall not be
observed.
√ √ √
There shall not be oil leaks in or around
transmission.
√ √
Drive Belt
Belt shall be free of damage or wear.
√ √
Inspecting: Page 41
Belt tension shall be properly adjusted.
√ √
Inspecting/Adjusting:
Page 41
Clutch
Clutch shall not make noise and shall
disengage completely when operated at idle.
√ √
Clutch shall not slip and shall engage
smoothly.
√ √
Brake
Brake shall work properly.
√ √ √
Inspecting/Adjusting:
Page 42
Brake shall be able to hold machine on a
25-degree slope.
√ √
Side Clutch
Side clutch shall work positively without
making irregular noise.
√ √ √
Lever play and stroke shall be properly
adjusted.
√ √
Inspecting/Adjusting:
Page 43
Wire shall be free of damage, excessive play
at joints, or rust on pins.
√ √
• Perform a pre-startup inspection (PSI) before each use, a monthly inspection once a
month, and a yearly inspection once a year.
• Some maintenance procedures described below may require special knowledge or tools
and instruments. Contact your CANYCOM representative to perform such procedures.
Chassis