Motorcycle Charging Mode
Charging procedure
1. Check the charger and ensure that it is the original one matched with the
battery.
2. Turn on the battery power switch.
3. Connect the charger output plug with the battery charging port (check
whether it is plugged in place).
4. Connect the mains power input terminal of the charger to the AC socket
(input voltage: AC110V-AC220V).
5. After 3-5 seconds, the charger indicator flashes, the fan rotates and the
charger start charging; after the battery is fully charged, the indicator turns
green and flashes.
6. After fully charged, cut off the commercial power supply, and then
Page18 of 61
remove the power plug.
Battery User Manual
● Before putting the battery into service, please ensure that it is original, and do not use other brands or types of batteries.
● Before use, check whether the battery is in good condition, and ensure that there is no obvious damage, liquid leakage, water immersion, smoking,
overheating, etc.
● For the safety during transportation, the rated capacitance of the battery is 50%-80% when it is delivered. Due to the influence of self-consumption
factors such as transportation and storage cycle, there is low battery power or even no power when the battery is used for the first time. It is normal,
and do not worry. Just charge it once according to the instructions.
● Do not connect the charger to AC power supply or charge the battery in a confined space or at high temperature.
To Next Page
Loading...