Drive Chain Adjustment
It is not correct to make the drive chain too loose or tight.
If the chain is too slack, it will be easy to detach from the sprocket,
causing incident.
If the chain is too tight, its
service life may be shortened and the
transmission resistance will be increased, accelerating the wear of the
chain, front sprocket, rear sprocket and chain guider, and some
components will be broken or damaged when overloaded.
The correct chain slack is shown in Figure 1:
The motorcycle chain should be adjusted in real time to keep its tightness
in at 20-
30mm. If the slack of the drive chain fails to meet the above
requirements, it should be adjusted.
The adjustment method is as follows:
Ke
ep the motorcycle parked upright, loosen the rear axle nut, adjust the
nut and bolt according to the slack of the chain, adjust the left and right
sides of the chain adjusting top block to the appropriate slack, and then
lock the rear axle nut and the adju
sting nuts on the left and right sides.
Specification and model of drive chain of CAOFEN Electric Motorcycle:
Rear sprocket: 420-128 links, 62 teeth per link
Cradle status: 420-130 knots
Rear sprocket: 420-134 links, 72 teeth per link
The chain guide is applicable to 62T and 72T rear sprocket.
Page 35 of 61
It is not correct to make the drive chain too loose or tight.
If the chain is too slack, it will be easy to detach from the sprocket,
service life may be shortened and the
transmission resistance will be increased, accelerating the wear of the
chain, front sprocket, rear sprocket and chain guider, and some
components will be broken or damaged when overloaded.
The motorcycle chain should be adjusted in real time to keep its tightness
30mm. If the slack of the drive chain fails to meet the above
ep the motorcycle parked upright, loosen the rear axle nut, adjust the
nut and bolt according to the slack of the chain, adjust the left and right
sides of the chain adjusting top block to the appropriate slack, and then
sting nuts on the left and right sides.
Specification and model of drive chain of CAOFEN Electric Motorcycle:
The chain guide is applicable to 62T and 72T rear sprocket.
If the locking clip of the chain is not clamped properly during chain
replacement, the chain may be detached, causing incident.
Chain adjusting
If the locking clip of the chain is not clamped properly during chain
replacement, the chain may be detached, causing incident.
Adjusting
20-30mm
To Next Page
Loading...