System Setup
System Setup
The system is set up at the factory. These steps are only required when modifications have been
made during installation or if changes were made to the machine after the PinPoint
™
II order was
placed.
1. Factory Reset
2. Location Setup Procedure
3. System Setup Procedure
4. Nozzle Setup Procedure
5. System Dry Test
6. System Wet Test
7. Look Ahead Time and Overlap Test
Factory Reset
Important: Always save your profile settings and/or record all settings and location setup information
before doing a factory reset.
A factory reset should be performed after:
• Initial installation
• Software update
• Major component change
• Operation mode change
©
2020 Capstan Ag Systems, Inc. 33 PinPoint
™
II
To Next Page
