CapstanAG PinPoint II - Spray Without the Pinpoint II System; Spray through the Capstanag Nozzle Valves; Spray through Alternate Valve Bodies

TM
Operation
Spray Without the PinPoint
™
II System
To spray without the PinPoint
™
system, use one of these:
• CapstanAG nozzle valves
• Alternate valve bodies
Spray Through the CapstanAG Nozzle Valves
• The display must be off.
• The rate controller will control the rate.
• The nozzle valves will open and close with the boom signal (without pulsing).
Spray Through Alternate Valve Bodies
Note: Use of alternate valve bodies is recommended for high flow applications (30 gal or more per
acre) if you do not have CapstanAG high-flow valve assemblies.
If using WILGER nozzle bodies:
• Disconnect the key switched power harness connector from the CapView harness.
• Install a cap onto the connectors.
The CapView must be off.
The rate controller will control the rate.
Manually open the drip checks.
©
2020 Capstan Ag Systems, Inc. 77 PinPoint
™
II