CapstanAG PinPoint II - Page 4

TM
Contents
Chapter 5: System Setup....................................................................31
CapView Button Descriptions................................................................................................... 31
Start the CapView.....................................................................................................................32
Shutdown the CapView............................................................................................................ 32
System Setup............................................................................................................................33
Factory Reset............................................................................................................................33
Do the Factory Reset Procedure...................................................................................34
Restore System Configuration or Select Settings.................................................................... 36
Change the Units of Measure.................................................................................................. 37
Do the Location Setup Procedure............................................................................................38
Do the Nozzle Spacing Setup Procedure......................................................................39
System Setup Menus................................................................................................................42
System Setup Menu Descriptions..................................................................................42
Advanced Settings—Synchro
™
Mode Operation...........................................................45
Advanced Settings—SharpShooter
™
Mode Operation..................................................51
Do the Nozzle Setup Procedure...............................................................................................56
Set the Preset Buttons...................................................................................................57
System Dry Tests..................................................................................................................... 58
Do the Boom Shutoff Dry Test...................................................................................... 58
Do the Key Fob Boom Shutoff Dry Test....................................................................... 59
System Wet Tests.....................................................................................................................61
Do the Boom Shutoff Wet Test..................................................................................... 61
Do the Key Fob Boom Shutoff Wet Test.......................................................................62
Do the Pressure Control Test...................................................................................................63
Do the Flow Control Test......................................................................................................... 63
Do the Look Ahead Time and Overlap Test............................................................................ 63
Do the Compass Calibration Procedure...................................................................................64
Setting the GPS Settings..........................................................................................................66
Machine Specific Information....................................................................................................68
Location Setup Information............................................................................................68
System Setup Information..............................................................................................70
Advanced Settings—Synchro
™
Setup Information........................................................71
Advanced Settings—SharpShooter
™
Setup Information...............................................73
Chapter 6: Operation...........................................................................75
Operate in Automatic Pressure Control (AUTO) Mode............................................................ 75
Manual Mode Operation........................................................................................................... 76
Spray Without the PinPoint
™
II System...................................................................................77
Spray Through the CapstanAG Nozzle Valves............................................................. 77
Spray Through Alternate Valve Bodies......................................................................... 77
Nozzle Display.......................................................................................................................... 78
Overlap Control.........................................................................................................................79
Mapping.....................................................................................................................................79
Upload a Boundary File to the CapView....................................................................... 80
Use a Map on the CapView.......................................................................................... 81
Download Maps..............................................................................................................82
CapMaps
™
—Boundary Mapping..............................................................................................83
Install the CapMaps
™
Software.....................................................................................83
Draw a Map................................................................................................................... 85
Convert a Shapefile into a PinPoint
™
II Map................................................................ 87
©
2020 Capstan Ag Systems, Inc. iv PinPoint
™
II