System Setup
Line Title
Line
Number
Description
Action
Minimum Valves ON Press ENTER to change.40
The minimum valves on defaults to 1. Reduces the over application of chemical product
with chemical injection. Used for chemical injection systems (not N-Ject
™
).
Navigation IMU Press ENTER to change.41
This feature must be enabled to allow quicker response time to the headings.
Note: The PSI NAV Commander Module must be mounted correctly for this feature to
function correctly.
Pressure Command Press ENTER to change.42
Enable this feature if the system is using a Raven PC2 Node to get the correct rate control
for the system.
GPS Lag Time Press ENTER to change.43
This is used to correct the delayed GPS signal from the antenna.
Factory Reset
Press ENTER and then YES to change.
44
The factory reset will require all setups in the entire system to be reset to default. The
factory reset is required when repairing the system. Make sure that you have recorded the
setups you prefer before resetting. With a properly prepared “cheat sheet,” a factory reset
only takes a few minutes. If major components are changed, a factory reset may need to
be performed.
Contact Information45
Selecting this line will open up a page with the CapstanAG toll-free phone number,
website, and a QRC code that will direct you to the website.
©
2020 Capstan Ag Systems, Inc. 50 PinPoint
™
II
To Next Page
