21
TABS? - Print Tab Settings, Cont.
ID=
(The IDentification string print position)
TIME=
(The Time print position)
DATE= (The Date print position)
CNC NO=
(The Consecutive Number print position)
GROSS=
(The Gross weight print position)
TARE=
(The Tare weight print position)
NET=
(The Net weight print position)
G ACCUM=
(The Gross weight accumulator print position)
N ACCUM=
(The Net weight accumulator print position)
COUNT=
(The Count (number of pieces on the scale) print position)
PCS WT=
(The Piece weight print position)
CNV NET=
(The Converted Units Net weight print position)
AUTO LF= (YES = data terminated with a carriage return AND a line feed)
(NO = data terminated with a single carriage return only)
ENDING LF
(Allowable values are: 0 through 99)
PRT END
(Print ending string)
FINE SPAN - Fine Span Adjustment (after the last Print Tabs prompt)
After the last Print Tabs prompt, the display will show
FINE SPAN? N
.
If Fine Span Adjustment is not desired, press the ENTER key to return to
SETUP
.
If Fine Span Adjustment is desired, press the 1/YES key, then the ENTER key.
With the display showing
ADJ=XXXXXX
,
Press the 1/YES key to increase the span
OR
Press the 0/NO key to decrease the span.
Press the ASTERISK key to return to the previous prompt,
TABS?
OR
Press the ENTER key to exit FINE SPAN and return to SETUP.
FINE SPAN - Fine Span Adjustment (using the Calibration Switch)
Press the Calibration switch until the display shows
FINE SPAN.
If Fine Span Adjustment is not desired, press the
ASTERISK
key to reset the indicator and
return to the normal operation weight display.
If Fine Span Adjustment is desired, place a calibrated test weight on the scale and press the
ENTER key.
With the display showing
ADJ=XXXXXX
,
Press the 1/YES key to increase the span
OR
Press the 0/NO key to decrease the span.
Press the ASTERISK key to return to the previous prompt,
TABS?
OR
Press the ENTER key to exit
FINE SPAN
and return to
SETUP
.
To Next Page
Loading...
