CL-4
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -- - - - - - - - - - - - - - - - - - - -
CUT ALONG DOTTED LINE CUT ALONG DOTTED LINE
C. Unit Start-Up (cont)
Use arrow/escape keys to illuminate configuration LED. Press ENTER key. Record information below.
UNIT (Configuration Settings)
Press ESCAPE key to display ‘UNIT’. Press down arrow key to display ‘OPT1’.
Press ENTER key. Record configuration information below:
OPTIONS1 (Options Configuration)
Press ESCAPE key to display ‘OPT1’. Press down arrow key to display ‘OPT2’.
Press ENTER key.
Record configuration information below.
OPTIONS2 (Options Configuration)
SUBMODE ITEM ITEM EXPANSION DISPLAY ENTRY
UNIT
UNIT CONFIGURATION
TYPE UNIT TYPE
SIZE UNIT SIZE XXX
SZA.1 COMPRESSOR A1 SIZE XX
SZA.2 COMPRESSOR A2 SIZE XX
SZA.3 COMPRESSOR A3 SIZE XX
A1.TY COMPRESSOR A1 DIGITAL? NO/YES
MAX.T MAXIMUM A1 UNLOAD TIME XX
EXV EXV MODULE INSTALLED? NO/YES
DITYP DISCHARGE GAS THERM TYPE X
SUBMODE ITEM ITEM EXPANSION DISPLAY ENTRY
OPT1
UNIT OPTIONS 1 HARDWARE
FLUD COOLER FLUID X
MLV.S MINIMUM LOAD VALVE SELECT NO/YES
RG.EN RETURN GAS SENSOR ENABLE DSBL/ENBL
OAT.E ENABLE OAT SENSOR DSBL/ENBL
CSB.E CSB BOARDS ENABLE DSBL/ENBL
CPC COOLER PUMP CONTROL OFF/ON
PM.DY COOLER PUMP SHUTDOWN DLY XX MIN
D.PM.E ENABLE CONDENSER PUMP DSBL/ENBL
D.FL.S ENABLE COND FLOW SWITCH DSBL/ENBL
CDWS ENABLE COND WTR SENSORS DSBL/ENBL
SUBMODE ITEM ITEM EXPANSION DISPLAY ENTRY
OPT2
UNIT OPTIONS 2 CONTROLS
CTRL CONTROL METHOD X
LCWT HIGH LCW ALERT LIMIT XX.X F
DELY MINUTES OFF TIME XX
ICE.M ICE MODE ENABLE DSBL/ENBL
To Next Page
Loading...
