Carrier AquaSnap 30MPA Series - Page 105

CL-5
C. Unit Start-Up (cont)
Press ESCAPE key to display ‘OPT2’. Press down arrow key to display ‘EXV.A’.
Press ENTER key.
Record configuration information below.
EXV.A (Circuit A EXV Configuration)
Press ESCAPE key to display ‘EXV.A’. Press down arrow key to display ‘CCN’.
Press ENTER key.
Record configuration information below.
CCN (CCN Network Configuration)
Press ESCAPE key several times to get to the mode level (blank display). Use the arrow keys to scroll to the set
point LED. Press ENTER to display setpoints.
Record configuration information below:
SETPOINT
SUB-MODE ITEM ITEM EXPANSION DISPLAY ENTRY
EXV.A
EXV.L
EXV OPENING AT LOW LWT XX%
LWT.L
LWT FOR EXV MIN OPENING XX° F
EXV.H
EXV OPENING AT HIGH LWT XX%
LWT.H
LWT FOR EXV MAX OPENING XX° F
MIN.A
EXV CIRC.A MIN POSITION XXX
RNG.A
EXVA STEPS IN RANGE XXXXX
SPD.A
EXVA STEPS PER SECOND XXXXX
POF.A
EXVA FAIL POSITION IN% XXX
MIN.A
EXVA MINIMUM STEPS XXXXX
MAX.A
EXVA MAXIMUM STEPS XXXXX
OVR.A
EXVA OVERRUN STEPS XXX
TYP.A
EXVA STEPPER TYPE 0,1
H.SCT
HIGH SCT THRESHOLD XXX
X.PCT
OPEN EXV X% ON 2ND COMP XX
X.PER
MOVE EXV X% ON DISCRSOL XX
DELY
LAG START DELAY XXX
L.DL.T
LOW SH DELTA T - EXV MOVE XXX
SHR.T
EXV RATE THRESHOLD XX.X F
L.EX.M
LOW SH OVERRIDE EXV MOVE X.X%
SUB-MODE ITEM ITEM EXPANSION DISPLAY ENTRY
CCN
CCNA CCN ADDRESS XXX
CCNB CCN BUS NUMBER XXX
BAUD CCN BAUD RATE X
SUBMODE ITEM ITEM EXPANSION DISPLAY ENTRY
COOL
COOLING SETPOINTS
CSP.1 COOLING SETPOINT 1 XXX.X °F
CSP.2 COOLING SETPOINT 2 XXX.X °F
CSP.3 ICE SETPOINT XXX.X °F
HEAD
HEAD PRESSURE SETPOINTS
H.DP HEAD SET POINT XXX.X °F
FRZ
BRINE FREEZE SETPOINT
BR.FZ BRINE FREEZE POINT XX.X °F