Carrier Connect 33CONNECTSTAT43FX - Changing the setpoints

To Next Page

To Previous Page

Getting to know the user interface

Changing the setpoints

You can change the setpoints from the home screen using the up and down arrows.

If the mode is:

• OFF—the setpoints, occupancy button, and the up and down arrows do not display

• HEAT or EHEAT—only the heat setpoint displays

• COOL—only the cool setpoint displays

• AUTO—both setpoints display

When changing the setpoints in AUTO mode, the setpoint modified by the up and down arrows is the last setpoint

that was changed. To adjust the opposite mode setpoint, touch the setpoint value on the display. HEAT TO or

COOL TO flashes above the setpoint and can be changed by using the up and down arrows. The setpoints enforce

a 2-degree deadband. Setpoints in °F are displayed in whole degrees. Setpoints in °C are displayed with half

degree resolution.

Pressing once on the center button at the bottom of the display changes the setpoints to either the program

schedule's occupied or unoccupied settings. The label on this button shows the opposite of the word above the

space temperature.

Example If the thermostat is in an occupied program period, the middle button displays UNOCC so you can

change the thermostat settings to the unoccupied values. Overriding the program schedule using the OCC/UNOCC

button modifies both the setpoint values and the fan setting.

A program schedule override is treated the same whether you manually change the setpoints or use the

OCC/UNOCC button. When an override is active, the center button label changes to RESUME SCHEDULE, the

period icon above the space temperature is not displayed, and the amount of time remaining in the override is

displayed in the banner. The thermostat returns to the program schedule value at the next programmed period,

when the max hold timer expires or if you press the RESUME SCHEDULE button.

NOTE If the thermostat is setup as a non-programmable thermostat or them MAX HOLD time is set to OFF, then

the bottom middle button is not displayed.

The installer designates and clamps setpoints within a range.

Related product manuals