Carrier Connect 33CONNECTSTAT43FX - To Restore Factory Default Settings

Using installer settings
Carrier Connect™ Wi-Fi Thermostat 33CONNECTSTAT43FX CARRIER CORPORATION ©2021
Installation Guide All rights reserved
46
To restore factory default settings
This setting allows the installer to reset all system settings back to factory default values.
From the RESTORE DEFAULTS screen, press and hold the DEFAULT button to start a 5-second countdown.
NOTES
• At the end of 5 seconds, the factory settings are restored.
• Release the DEFAULT button to cancel the countdown at any time before the 5 seconds elapse.
• After the factory settings are restored, the control returns to BACNET ENABLE to allow the installer to properly
configure the thermostat.
Screen
Factory defaults
HEATING EQUIP TYPE
GAS
HEATING EQUIP STAGES
1
COMPRESSOR EQUIP TYPE
A/C
COMPRESSOR EQUIP STAGES
1
AUTO ALLOWED?
YES
AUTO CHANGEOVER
30 MIN
PROG OR NON-PROG
PROG
MAX TEMP HOLD TIME
2
FAHRENHEIT OR CELSIUS
°F
SMART RECOVERY
30
FAN ON WITH W
YES
REVERSING VALVE
COOL
SPACE TEMP OFFSET
OFF
SPACE HUM OFFSET
0%
HUM SOURCE
STAT
REMOTE HUM SCALING
2-10
REMOTE SENSOR
NONE
COOL LOCKOUT
OFF
LOW COOL LOCKOUT TEMP
OFF
LOW HEAT LOCKOUT TEMP
OFF
TIME B/W FUEL TYPES
15 MIN
CYCLES PER HOUR
4
HUMIDIFIER
NO
DEHUMIDIFIER
NO
MAX HEAT SETPOINT -
88°F
MIN COOL SETPOINT
52°F