Carrier RTU OPEN 11-808-427-01 - Start-up

RTU Open 35
To start up the RTU Open, you need one of the following user interfaces to the controller. These items let you
access the controller information, read sensor values, and test the controller.
This interface...
Provides a...
i-Vu Open
Permanent interface software
Field Assistant
software -
runs on a laptop connected to controller's Local Access port
Temporary interface
1
Virtual BACview
software -
runs on a laptop connected to controller's Local Access port
Temporary interface
1, 2
BACview6 Handheld
keypad/display unit -
connects to controller's Local Access port
Temporary interface
1, 2
BACview6
keypad/display unit
connected to controller's Rnet port
Permanent interface
2
1
Requires a USB Link (USB-L).
2
See the BACview Installation and User Guide for instructions on connecting and using the above items.
Start-up