1 Network Installation
7
1.5 Installing the Slave Scales (#2 -32)
1. Install slave scale in its final location.
2. (Optional) Span calibrate the scale and go to REG mode when done.
3. Follow all of the directions for section 1.1 Installing the Network Memory Card.
4. Continue for this procedure (steps 1 to 4) for all slave scales #3 to #32.
5. All scales should be OFF at this time.
1.6 Installing the Master Scale (#1)
1. Install the Master scale in its final location.
2. (Optional) Span calibrate the scale and go to REG mode when done.
3. Follow all of the directions for section 1.1 Installing the Network Memory Card.
4. The Master scale should be OFF at this time.
5. If Pc master is selected, don’t use master scale number(#1)
To Next Page
Loading...
