CAS LP-II - Scale Master Ethernet Connection with PC

1 Network Installation
4
1.3.2 Scale Master Ethernet Connection with PC (RS232C)
PC
Master Slave Slave Slave
HUB
NOTE: Only 32 scales can be connected in this method.
IN the Manager Program, go to Config and select Scale Master (RS-232C)
1. Scale number (for master) : 1
2. Scale number (for slave) : 2~32
3. Network is Used: Yes
4. PC Mater is Used : No
5. RS232C SPEC (all of these should default when RS-232C is selected in manager)
baud rate : 19200 bps
data length : 8 bit
parity : none
stop bit : 1 bit