2 Network Management
8
2 Network Management - Program Mode
Enter the Program Mode : refer to owner’s manual
When the screen is at the Main Menu Press 0, enter a level 3 password when prompted, and then the
screen will read:
NOTE; THESE OPTIONS WILL ONLY APPEAR WHEN THE SCALE IS SET TO #1 UNDER NETWORK OPTIONS IN THE
CALIBRATION MODE
2.1 Network Mode
Once at the NET : NETWORK MANAGEMENT menu screen, press the 1 key. The Scale Mode Settings
screen will appear as follows:
The Network Setting option allows you to change the scale’s number. The scale number is a unique
identifier for networking. There can be 32 scales on a CAS NETWORK. Each scale must have a unique
number; therefore, no two scales may share the same id. Scale 1 is the Master scale. Scale numbers 2
through 32 are slaves. You can either activate or deactivate the network, or you can use Floating Clerk
or non-Floating Clerk.
< NET: NETWORK MODE >
1.Network Setting
2.Clerk Mode Setting
3.Application
< NET : NETWORK MANAGEMENT >
1.Network Mode 4.LOCK
2.Network Copy 5.UNLOCK
3.PLU Delete 6.Check Scale
To Next Page
Loading...
