2 Network Management
13
2.5 Unlock Network
Once at the NET: NETWORK MANAGEMENT menu screen, press the 5 key. The scale will place the
UNLOCK command on the network queue and wait for you to return to <REG> mode. To return to
<REG> mode, press ESC until you get to <REG> mode.
The LOCK and UNLOCK features are especially useful when you wish to do sales reporting and you do
not want anyone to register any sales before you finish your reports
This is different from the LOCK scale option on the Main menu. The LOCK scale option of the Main
menu only locks the scale in which you select the LOCK scale option. It then requires a level 1
password to unlock as opposed to the Network Lock, which can only be locked and unlocked by the
Master scale.
If you have a scale that is Network Locked and you cannot unlock it through the master, please
contact your Authorized CAS Dealer for service. You may have a network hardware problem, or a
scale hardware problem.
Scale oneself lock/unlock : if you press ALT and 1 key in any program mode, lock command is sent to
oneself. When you want to return program mode, press any key and level one password.
2.6 Check Scale
Once at the NET: NETWORK MANAGEMENT menu screen, press the 6 key. You will then see the Check
Scale screen as follows:
The scale number means that the master was able to see that node; “.” indicates a failure to
communicate to that node.
If you have problems with this test, please review the network installation instructions and run the test
again. If a problem persists, contact the CAS Service Department.
<REG> 12:12:00 PM
WEIGHT lb UNIT $ / lb TOTAL PRICE $
◀
○
1 . 3 . 5 . . . . .
. . . 14 . . . . . 20
. . . . . . . . . .
. 32
To Next Page
Loading...
