11
ZERO KEY
Used to remove small variations in the indicator’s zero
If pressed for 2~3 sec, you can go to SYSTEM Mode
TARE KEY
Used to weigh an item by using the container
Current weight is memorized as tare weight
If pressed in unload condition, tare setting is released
If pressed for 2~3 sec, you can go to KeyTare Mode
When you know the tare weight, you can enter the tare weight
GROSS / NET KEY
It means NET lamp is on for Net & off for Gross weight
If pressed for 2~3sec, you can see “On” and input Product ID
If pressed for 2~3 sec, you can “CodE=Z lim=t”. Then you can Input
Product ID with ZERO, Limit value with TARE key.
PRINT KEY
If you print, current weight is added to total weight
If pressed for 2~3 sec, you can see "SUB = Z GrAn = T".
You can print out the sub total weight with ZERO key and
total sum weight with TARE key
After the sub total weight and grand total weight is printed out, it is set
to zero(0)
ENTER KEY - Used as HOLD key
If pressed for 2~3 sec, you can see “dEvi = Z Set = t”.
You can go to DEVIDE with ZERO, SET Mode with TARE key
UNIT KEY
You can change the unit of weight ( kg/lb ) (USA Version)
All functions are used with the unit of weight is selected
in weight calibration in CAL MODE.
If you press UNIT key for 2~3 sec, power is turned on or off
To Next Page
Loading...
