3-1
SECTION 3
OPERATING THE MACHINE
GENERAL INSTRUCTIONS
BEFORE OPERATING THE MACHINE
Before operating the machine, observe the following
instructions:
- Check the levels (engine oil, hydraulic fluid and
coolant fluid) and make sure that the various flu-
ids correspond to the conditions of use.
- Carry out the daily maintenance operations.
- Walk around the machine, look for any leaks and
inspect the hoses.
- Before undertaking any road travel, lock the
equipment, and connect the safety systems
required by regulations.
- Before any road travel or job site work at night,
check that the lighting and signalling systems are
operating correctly.
- Check the condition of the tyres and the tyre pres-
sure.
- Clean the steps and access handles and your
shoes. The presence of oil, mud or ice (winter)
can cause accidents. Make sure they are always
clean.
- Clean or replace safety decals which are no
longer legible.
- Make sure that the engine hood is closed and
latched correctly.
- Check that the cab door is closed correctly.
- Remove anything which might hinder visibility.
Clean the windshield windows and rear view mir-
rors.
- Make sure that no objects or tools are left on the
machine or in the operator’s compartment.
- Make sure to know the escape manoeuvres from
machine (emergency exit).
- Make sure that nobody is under or on the
machine. The operator should be the only person
on the machine.
- Make sure that nobody is within the working range
of the machine.
OPERATING THE MACHINE
When operating the machine the following instruc-
tions must be observed:
- Start the engine taking into account weather con-
ditions.
- Regularly consult the hourmeter to ensure Main-
tenance Intervals are observed.
- If you use the machine under particularly severe
conditions (dusty or corrosive atmosphere, etc.),
the Maintenance Intervals should be reduced.
- Make sure that you know the location of pipes and
cables before beginning work.
- Do not work near overhead high-voltage electrical
cables without checking beforehand that all nec-
essary measures have been taken to respect the
minimum distances: 5 metres.
- On job sites on the public highway, use regulation
signals, taking into account the working range of
the machine. Local regulations define the number,
type and location of reflective strips.
- Make sure that the operator’s seat is correctly
adjusted and positioned.
- Never operate any control or driving component
unless you are seated correctly in the operator’s
seat with the seat belt adjusted and attached cor-
rectly.
- Adapt your operating style to the type and condi-
tions of work.
- Do not allow anyone to stand in the machine
working area. Stop all movement until the person
has moved away.
- Operate all controls progressively so the machine
works smoothly.
- When loading the machine onto the trailer of an
articulated vehicle, see “Transporting the
machine”.
- When towing the machine, see “Machine recovery
and towing”.
- Avoid running the engine in an enclosed space. If
necessary, ensure good ventilation under all cir-
cumstances.
S WARNING S
Read and assimilate the instructions and warnings
shown in this manual before operating the
machine.
S WARNING S
Check that all the controls and all the safety
devices operate correctly in a safe, clear area
before beginning work.
To Next Page
Loading...
