SUPPLIES AND SERVICE CHART
4-5
SAFETY INSTRUCTIONS
No inspection and maintenance work may be car-
ried out until the Operator’s Manual has been read
and understood.
Any modification to this machine without prior
authorization could cause serious injury. Do not
make any modifications without authorization. Con-
sult your Dealer.
Respect the maintenance intervals prescribed by
this Manual carefully.
IMPORTANT: if you use the machine under particu-
larly severe conditions (dusty or corrosive atmos-
phere, etc.) reduce the intervals between
maintenance operations.
MACHINE SAFETY
Before carrying out any maintenance or repair work
the machine must be secured as follows:
- park the machine on flat and firm surface;
- place the working equipment on the ground;
- lock the upper structure;
- apply the parking brake;
- shut off the engine;
- move both hydraulic control levers in all directions,
to release possible residual pressure inside of the
hydraulic system;
- disconnect the pilot control;
- set the ignition key to position “0” and pull it out;
- secure machine with wheel chocks to avoid its
rolling or overturning.
MAINTENANCE PERSONNEL
Inspection and maintenance personnel must have
the necessary know-how on the inspection and
maintenance of this or comparable machines.
The necessary know-how can be acquired in sev-
eral days’ instruction, for instance by a specialist fit-
ter or by attending a training course.
S CAUTION S
There is a risk of serious injury if maintenance or
repairs are not performed correctly. If you do not
understand the maintenance procedures, consult
your Dealer.
3
To Next Page
Loading...
