E-50
Attaching the Stylus (Pen)
Use the procedure below to attach the stylus (pen).
1. Thread the thin cord loop on the stylus (pen)
through the hole in the hand belt for attaching
the stylus (pen).
2. Pass the stylus (pen) tip-fi rst through the thin
cord loop.
• When you are not using the stylus, always place
it in the stylus holder.
Fitting the IT-G400 into the Cradle with the Hand Belt Attached
When fi tting the IT-G400 into a cradle (HA-R60IO, HA-R62IO or HA-R38CHG), remove
the lower end mount from the IT-G400 beforehand.
1. Remove the lower end mount of the hand belt
from the IT-G400.
Tip!
Adjust the belt to a convenient length (so that
the end of the hook and loop fastener is level
with the guide line) before pulling the lower
end mount off the IT-G400.
Stylus
attachment hole
Stylus holder
Pull slowly in the
direction indicated
by the arrow.
To Next Page
Loading...
Need help?
General