Recording Performances
EN-110
■ MIDI Recorder Recording Settings
A MIDI recorder song has two recording tracks (system track and solo track), and you can choose
which track to record to. A precount can also be set to indicate when recording will begin.
1.
Perform the operation described in steps 1 through 4 of “Recording with the MIDI
Recorder” (page EN-107).
The 0REC button flashes red and the Digital Piano is ready to record.
2.
Touch and hold the 0REC button.
The “RECORD SETTING” screen appears (record standby is maintained).
3.
Touch the top or bottom of the touch ring to select the setting you want to
change.
• The table below shows the setting values and settings for each setting item.
4.
Change the setting of the selected item.
• Trace the touch ring to change the desired setting.
5.
Repeat steps 3 and 4 as necessary.
6.
To start recording with the changed settings, resume operation from step 5 of
“Recording with the MIDI Recorder” (page EN-107).
• To stop recording at this point, touch the 0REC button. The 0REC button will light up white
again.
Setting item Setting values and descriptions
Rec Track
System: Records to the system track.
Solo: Records to the solo track.
For the recording content of each track see “Items Reflected in Contents When
Recording to the MIDI Recorder Song” (page EN-114).
Precount
Sets the pre-count before recording begins
Off: Pre-count is not sounded
1 Measure: One-bar measure pre-count
2 Measures: Two-bar measure pre-count
To Next Page
Loading...
Need help?
General
