EN-25
• Unless otherwise specifically noted, all of the procedures in this manual assume that the
Digital Piano is in its initial power on state (immediately after you turn on power). If you run
into problems with a procedure, turn Digital Piano power off and back on, and then try
performing the procedure again.
• Note that turning off Digital Piano power during a procedure causes any pending unsaved
data to be deleted.
Turning on Digital Piano power causes the touch buttons and touch ring to light.
The touch ring is used to move the cursor between items on a list and to change values.
* While the close-up screen (page EN-29) or the value list screen (page EN-30) is being displayed,
touching the top or bottom of the touch ring changes values.
Operations Common to All Modes
Using the Touch Buttons and Touch Ring
Touch Ring Basic Operation
• Trace along the touch ring to continuously
change the value of the currently selected item
on the screen.
• Touch the left or right of the touch ring to
change the value one unit at a time. Touch the
top or bottom of the touch ring to move the
cursor between items
*
.
Tracing clockwise (+) along the touch ring until
the value becomes its maximum value, it will stop
at that value. Likewise, tracing counterclockwise
(–) along the touch ring until the value becomes
its minimum value, it will stop at that value.
Touching the left of the touch ring (–) after the
minimum value is reached sets the maximum
value. Likewise, touching the right of the touch
ring (+) after the maximum value is reached sets
the minimum value.
Decrease the
value (–)
Increase the
value (+)
Move the cursor up (↑)
*
Decrease the
value (–)
Increase the
value (+)
Move the cursor down (↓)
*
To Next Page
Loading...
Need help?
General
