Saving and Recalling Performance Setups (Registration)
EN-82
1.
Select the bank of the setup you want to recall by performing Steps 2 through 4
of “Saving a Setup Registration” (page EN-80).
• This procedure is not necessary if you want to recall the registration from the currently selected
bank.
2.
Turn the Freeze function on or off as needed.
• For more information, see “Freeze Function” (page EN-83).
3.
Select the “03 Registration” of the F Button Set. See “To change the F Button
Set” (page EN-32).
4.
Touch one of the F buttons (F1 to F4).
The corresponding registration (REG 1 to REG 4) is recalled.
Recalling a Setup Registration
The [ ] indicates that registration was recalled
To Next Page
Loading...
