20
Use the procedure below to adjust the volume level of the projector’s speaker output, and output from
the AUDIO OUT terminal. If your projector does not have a built-in speaker, only AUDIO OUT terminal
output is affected.
To adjust the volume level
1.
Press the [VOLUME +] or [VOLUME –] key.
This causes the “Volume” screen to appear on the projected image.
2.
Press the [VOLUME +] key to increase the volume, or the [VOLUME –] key to
lower the volume.
3.
After the setting is the way you want, press the [ESC] key.
To mute the audio
1.
Press the [VOLUME +] or [VOLUME –] key to display the “Volume” screen.
2.
Press the [ENTER] key.
This stops output from the speaker.
3.
To restore the audio, press the [VOLUME +] or [VOLUME –] key.
Adjusting the Volume Level (VOLUME)
To Next Page
Loading...
