84
Command List
Only the following functions are supported while the projector is turned off. Do not try to send any
other command to the projector.
Input of a valid signal must be in progress in order to use a command to turn on blank screen or
change the aspect ratio.
R: Read enabled W: Write enabled
Power on/off: Read
Power on: Write
Get light time: Read
Function
Command
Name
RW Settings
Power On/Off: PWR RW 0: Off, 1: On
Input Switching:
0: Switches the input source to the COMPUTER terminal
and changes the COMPUTER terminal setting to RGB.
1: Switches the input source to COMPUTER terminal and
changes the COMPUTER terminal setting to component.
2: Switches the input source to Video.
6: Switches the input source to COMPUTER terminal and
changes the COMPUTER terminal setting to Auto.
7: Switches the input source to “HDMI”.
8: Switches the input source to “Network”.
9: Switches the input source to “S-Video”.
11: Switches the input source to “File Viewer”.
12: Switches the input source to “USB Display”.
13: Switches the input source to “CASIO USB Tool”.
14: Switches the input source to “HDMI2”.
Settings 2, 9, and 14 are valid for XJ-F Series projectors
only.
Settings 8, 11, 12, and 13 are valid for network model
projectors only.
SRC RW 0: RGB, 1: Component
2: Video
6: Auto (RGB/Component)
7: HDMI, 8: Network
9: S-Video, 11: File Viewer
12: USB Display
13: CASIO USB Tool
14: HDMI2
Blank Screen: Switches the blank screen on or off. BLK RW 0: Off, 1: On
Volume: Specifies a value to adjust the volume level. This
setting is applied to the input source signal that is
currently being projected by the projector.
VOL RW 0 to 30
Color Mode: Selects the color mode. PST RW 1: Graphics, 2: Theater
3: Standard, 4: Blackboard
5: Natural
Aspect Ratio:
Specifies the aspect ratio.
Setting 0 is the “Normal” setting when the input source is
“RGB” or “HDMI(PC)”, while setting 2 is the “Normal”
setting when the input source is component, “HDMI(DTV)”,
“Video”, or “S-Video”.
ARZ RW 0: Normal, 1: 16:9
2: Normal, 3: Letter Box
4: Full, 5: True, 6: 4:3
7: 16:10
Get Light Time: Gets the light time from the projector. LMP R 0- Unit: Hours
To Next Page
Loading...
