cectek Kingcobra - Engine Coolant Solution Level

30
Engine Coolant Solution Level
1. Conrm the engine is cold and remove front access panel.
2. Put the vehicle on a level surface.
3. Remove the rubber cap of the reservoir.
4. Fill the engine coolant solution into the reservoir under the front access panel.
5. Make sure the engine coolant solution level is between MAX. and MIN. marks. Do not over
ll.
6. Reinstall the reservoir cap. Run the engine for few minutes and check the engine coolant
solution level still in the normal range.
Engine Coolant Fill Cap
1
Engine Coolant Fill Cap
1