The recoil starter is used to start the engine when the battery is weak.
To operate the recoil starter:
1. Turn the transmission gear shifting knob to “N” position.
2. Select the engine stop switch to “Engine Stop” position.
3. Grip the starter rope handle.
4. Slowly pull the rope until feeling the starter engage.
5. Pull the rope slowly to dry crank the engine.
6. Select the engine stop switch to “Engine Run” position.
7. Grip the starter rope handle.
8. Forcefully pull the rope to start engine.
9. After the engine starts, be sure to return the starter rope back to original position and seal
the hole.
NOTE:
•
The engine also can be started in other transmission gear position when you fully pull the
brake lever or press down the foot brake pedal.
•
When operating the recoil starter, please turn off all lights.
When you start the engine not in idle throttle lever position by recoil starter, the recoil
starter handle may reverse to damage the ATV and hurt the people.
Always follow the procedure of operating recoil starter. If you feel hard to dry crank the
engine, stop operating the recoil starter and contact authorized CECTEK dealers.
Never press the throttle lever when you operate the recoil starter.
Warning
(10) REAR BOX
Rear box rubber strip
Storage for the small or light articles such as gloves, map or small packages.
Pull the rubber strip out and open the door of box. The maximum total weight of goods should
not be over 1 kg.
1
1
To Next Page
Loading...
