DRIVING IN COLD WEATHER
Pre-ride Inspection
Conrm the throttle and all control levers moving freely. Make sure that all brake levers, switch,
seats, footrest, and gear selection knob are free of ice or snow.
Before driving, shift the gear selection knob to N (Neutral) position, move the vehicle forward
and backward to conrm that all parts move freely.
If the tires are frozen to the ground, pour warm water around the tires to melt the ice. If the
brakes are frozen, bring the vehicle to the warmer area to thaw out the brakes.
After warm up the engine, inspect the ATV, drive the ATV slowly not over the walking speed for
certain distance, and conrm the brake efciency.
If you found any problem during above inspection, do not drive this vehicle and contact
CECTEK authorized dealer.
CAUTION
Using engine power to free up frozen parts can
damage the vehicle.
Before driving , shift the gear selection knob to N
(Neutral) position, move the vehicle forward and
backward to conrm that all parts move freely.
Operating the vehicle with mal function brake system can be hazardous.
Wet or frozen brakes will reduce the stopping ability. That will increase the chance of
having an accident.
Any water that enters the brakes while ride the vehicle. The water may freeze after parking
the vehicle. That can prevent the wheels from turning or brakes from working.
After driving through water, mud, snow, or slush, it is important to dry the brake before
parking the vehicle, To dry the brakes, apply the brakes several times with slowly speed.
Always check the brake system before driving.
Warning
CAUTION
lnstall this vehicle with automotive-size battery can
damage this vehicle.
The high-amperage battery can damage the electric
system.
Use the battery same as the specification to start
the engine. Refer to “Maintenance” section for the
proper battery charging procedure.
NOTE:
If the temperature is below the -10°C (14°F), must change the oil for suitable temperature and
install the engine block heater.
To Next Page
Loading...
