STARTING THE ENGINE
Follow below steps to start the engine:
1. Set the parking brake lock
2. Shift the transmission gear knob to “N’ (neutral) position.
3. Turn the main switch to “ON” position.
Turn the engine stop switch to “ ” position.
4. Check the instrument: only “Engine Check Warning” and “Oil Pressure Warning” are
illuminated.
5. Press the start button to start the engine.
6. Check the instrument: “Engine Check Warning” and “Oil Pressure Warning” should be off.
This vehicle has two systems for engine starting. You can use the electric starter or the recoil
starter. The recoil starter is used to start the engine if the vehicle’s battery is weak. When you
use the recoil starter, refer to the “CONTROLS” section in this owner’s manual.
NOTE:
1.Open the throttle briefly to raise the idle speed if the idle speed is low after starting the
engine.
Running the engine in closed space without proper ventilation can be hazardous.
Breathing in exhaust gases from this vehicle can cause death or severe injury.
Always ride your vehicle outdoors.
Warning
Engaging the starter motor more than ve seconds at a time can damage this vehicle.
That could cause the start motor and wiring harness overheat.
If the engine can not start after several tries, check the fuel supply and ignition system
first. If you still can not start the engine successfully, contact CECTEK authorized
dealers.
Warning
To Next Page
Loading...
