Brake Fluid
Only DOT 3 brake uid can be lled into the brake system.
CAUTION
Use brake fluid other than the DOT3
or mix different brake uids for topping
up could cause serious damage of
your vehicle.
Brake Fluid Level
1. Put the vehicle on a level surface. Remove the front access panel.
2. Turn the steering handle in the neuter position and conrm the hand brake reservoir is level.
3. Conrm the brake uid is above the MIN. mark.
4. Clean ller cap before removing.
5. Unscrew the two bolts on the ller cap and remove the reservoir cap on the steering handle.
Turn the cap of reservoir under the front access panel counterclockwise to remove the cap.
6. Fill the DOT 3 brake uid in to the reservoir.
7. Reinstall the ller cap. Visually inspect and conrm no leakage of brake uid.
Engine Coolant Maximum Level
1
1
To Next Page
Loading...
