When the differential lock function is activated, this vehicle has a solid rear axle. Both rear
wheels always turn at the same speed. For turning of the vehicle, the outside rear wheel must
travel a greater distance than the inside rear wheel. Therefore, unless the inside rear wheel of
the turn is allowed to slip or lose some traction, the vehicle will resist turning.
Turning skill must be learned rst at low speed.
To turn the vehicle, you must follow the proper procedures below. This will let the inside wheel
of the turn slip slightly when in differential lock mode, allowing the vehicle to make the turn
properly.
1. Slow down and begin to turn the handlebars in the desired direction.
2. Move your body weight forward and to the inside of the turn.
FOR HIGHER SPEEDS OR SHARPER TURNS:
Use the same technique as turn at low speed, but move your body weight farther toward the
inside of the turn to balance the vehicle. If your vehicle starts to tip while turning, lean your body
farther into the turn while gradually reducing the throttle and making the turn wider.
SKIDDING OR SLIDING
Overcoming skidding or sliding
improperly can be hazardous.
Overcoming skidding or sliding
improperly can cause to lose
your control of the vehicle or
regain traction unexpectedly and
overturn.
Learn to safely deal skidding or
sliding by practicing at low speeds
and on level smooth terrain.
On extremely slippery surfaces,
such as ice, go slowly and be
very cautious in order to reduce
the chance of skidding or sliding
out of control.
Warning
To Next Page
Loading...
