cectek Kingcobra - Pre-Operating Check

66
PRE-OPERATING CHECK
If pre-operating check is not done properly, severe injury and death can be occurred.
Pre-operation check is compulsory before operating the vehicle. All safety features,
mechanical components, and critical control functions must be checked before operating.
Always follow the pre-operation check procedure to check the vehicle before operation.
If you nd any inconsistency of the vehicle function, specications, parts and component,
contact CECTEK authorized dealer immediately.
Warning
•
Apply parking brake and check if brake effect is enough to stop the vehicle.
•
Check tire pressure, air leakage, crack, worn-out or damage.
•
Check wheels and bearing for wear or damage.
•
Check all control functions.
•
Check if the steering works well.
•
Check if the throttle lever can move freely in full travel and back to idle position when
released.
•
Apply hand and foot brake, check the brake efciency, conrm lever and pedal fully return
when released.
•
Conrm the transmission gear can be selected in all positions.
•
Check all liquids levels.
•
Conrm no any liquid leakage on the vehicle.
•
Clean headlights and taillights.
•
Ensure front and rear box covers are properly latched.
•
Ensure seat is properly latched.
•
Ensure the total vehicle weight with payload is not over the specications.
•
If you are towing a trailer or other equipment, ensure the trailer and equipment is not over the
specication.
•
Conrm no loose parts on the vehicle when the engine is off.
•
Ensure the path of travel is free of person or obstacles.
•
Check all lights.
•
Start the engine and drive forward slowly and apply the brakes individually to test the
efciency of brake.
•
Check 2WD/4WD (only applicable to Gladiator) selection function.
•
Check differential lock function.
Correct any problem during the pre-operation check. If you nd any problem, stop the operation
and contact CECTEK authorized dealer immediately.