Page 37For technical questions, please call 1-888-866-5797.Item 62120
Inspection and Maintenance
Procedures not specifically explained in this manual
must be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ELECTRICAL SHOCK:
Make sure that the Scan Tool is unplugged from the vehicle
before performing any procedure in this section.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
Inspection
1. BEFORE EACH USE, inspect
the general condition of the
Scan Tool. Check for:
• cracked or damaged Cable,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
Cleaning and Storage
1. AFTER USE, use a mild detergent
on a clean cloth to remove any oil,
grease or dirt from the Scan Tool,
especially on the buttons, being
careful to not put excessive
pressure on the Display Screen.
2. Do not use solvents on the Keyboard.
Do not soak the Keyboard, Use a mild
nonabrasive detergent and a soft cloth.
3. Store the Scan Tool, and accessories
away from sunlight in a dry, locked
area, out of the reach of children.
To Next Page
Loading...
Need help?
General
