Page 7For technical questions, please call 1-888-866-5797.Item 62120
I/M Monitors
Inspection and Maintenance diagnostic tests that the Control Modules
perform on specific sub-systems of the vehicle.
There are two types of Monitors:
• Continuous: Monitors that
perform tests all the time while
the engine is running.
• Non-Continuous: Monitors that require
specific operating conditions to be met
during a Drive Cycle in order for the
Monitors to run their testing sequences.
Note: Not all Monitors are
supported by all vehicles.
Gasoline Engine Monitors
Continuous
MIS - Misfire
FUEL - Fuel System
CCM - Comprehensive Components
Non-Continuous
CAT - Catalyst
HCAT - Heated Catalyst
EVAP - Evaporative System
AIR - Secondary Air System
O2S - Oxygen Sensors
HTR - Oxygen Sensor Heater
EGR - EGR System
Diesel Engine Monitors
Continuous
MIS - Misfire
FUEL - Fuel System
CCM - Comprehensive Components
Non-Continuous
HCCAT - NMHC Catalyst
NCAT - NOx Aftertreatment
BP - Boost Pressure System
EGS - Exhaust Gas Sensor
PM - PM Filter
EGR - EGR System
To Next Page
Loading...
