CertoClav Vacuum Pro 45 - Default Chapter; Table of Contents

Instruction Manual CertoClav Vacuum Pro 45 l — Model STE-45-T
3
1 General Information 6
1.1 Intended use 6
1.2 Environmental protection 6
1.3 Customer Service 6
1.4 Ordering spare parts and special accessories 7
1.5 Guarantee 7
2 Meaning of the Symbols on the Autoclave 8
3 Safety Information 9
4 Non-autoclavable Substances 10
5 Initial Start-up 11
5.1 Device description 11
5.2 Device dimensions 11
5.3 Scope of supply 12
5.4 Before initial start-up 12
6 Installation 13
6.1 Setting up the autoclave 13
6.2 Unlocking the autoclave door 14
6.3 Touchscreen assembly 14
6.4 Installing accessories 16
6.4.1 Connecting the protocol printer 16
6.4.2 Connecting the barcode reader 16
6.4.3 Connecting the label printer 16
6.4.4 Connecting the CertoServer 17
6.5 Pressure sensor calibration 17
6.6 Validation and calibration 18
7 Sterilisation Programs 19
7.1 Default settings 19
7.2 Editing program parameters 20
8 Basic Operation 21
8.1 Switching on the touchscreen 21
8.2 Switching off the touchscreen 21
8.3 Standby Mode for the touchscreen 21
9 Instructions for Daily Use 22
9.1 Preparations before use 22
9.2 Replenishing with distilled water 22
9.3 Opening the autoclave door 23