Instruction Manual CertoClav Vacuum Pro 45 l — Model STE-45-T
60
Used water
connection
Fresh water
connection
14 Transport and Storage
Always keep the transport crate in which the autoclave was delivered.
14.1 Preparations
Allow the autoclave to cool down and pull the mains plug out of the socket.
14.2 Emptying the water containers
Please empty all internal water tanks: Connect the wastewater hose to the wastewater
port for the fresh and used water. Activate the drain by pulling on the connection port.
Press the connection port back towards the autoclave to stop the flow.
14.3 Transport conditions
Please contact your dealer.
Do not drop the autoclave during transport
14.4 Storage conditions
The autoclave should be stored in a dry place at a room temperature between 5°C to
maximum 40°C. The relative air humidity must not be higher than 80%. Make sure that
the store is well ventilated and does not contain any corrosive gases.
To Next Page
Loading...