Ceru vu+ ultimo - Resetting TV Setup for RCU; System Code Change for RCU

73
Vu User Manual
+
1. Press 1and 6 for three seconds until LED is on.
2. Press <9>, <9>, <3>.
3. If you want to control of TV volume, press TV Power button. If you want to control STB volume, press
STB Power button.
5. Reset of TV Set-up
In case you want to reset the configured TV set-up of your RCU,
Press Sequence:
<<1 + 6>>, <9>, <9>, <6>
1. Press 1and 6 for three seconds until LED is on.
2. Press <9>, <9>, <6>.
3. This will reverse the RCU into no configuration state.
6. System Code Change.
You can change the system code of your Vu+ universal RCU according to the Vu+ model that you want to
control. The default system code is Mode 2.
Mode 1 : SOLO / DUO
Mode 2 : UNO / Ultimo
(*Note : The keyboard of Ultimo remote cannot be used for SOLO,DUO & UNO.)
Mode 3 & 4 : reserved for future models.
Press <<2 + 7>>, <HELP>, <0001 or 0002 or 0003 or 0004>
1. Press 2 and 7 for three seconds until LED is on.
2. Press HELP
3. Press <0001 or 0002 or 0003 or 0004>
DISCLAIMER
Vu+ universal remote controller (RCU) is developed with Philips Electronics. The database used in the Vu+
RCU supports more than 90% of the TV brands available on market. This means that your TV may not be
compatible with this universal RCU in some rare cases. In this case, Vu+ RCU can be used only for Vu+
set top box.